- Board ini berbasis ESP12E Serial WiFi SoC dengan onboard USB to TTL menggunakan IC CH340 (USB to UART Bridge Virtual COM Port)
- Dapat di program langsung lewat USB, tanpa menggunakan rangkaian tambahan.
- Development Board dengan Open-Source Firmware ini dapat dipergunakan untuk mendevelop aplikasi IoT hanya dengan beberapa baris Lua script.
- Wireless standard : IEEE 802.11b/g/n
- 6 x Digital I/O, 3 x PWM Channels, 1 x ADC Channel
- Full I/O control through WiFi network
- GPIO with 15mA current drive capability
- Supports Smart Link intelligent networking
- Built in 32-bit MCU
- built-in TCP/IP protocol stack, and support multiple TCP Client connection
- UART/GPIO data communication interface
Features:
- Open-source
- Interactive
- Programmable
- Low cost
- Simple
- Smart
- WiFi enabled
- Arduino-like hardware IO
- Advanced API for hardware IO, which can dramatically reduce the redundant work for configuring and manipulating hardware
- Code like Arduino, but interactively in Lua script
- Nodejs style network API
- Event-driven API for network applicaitons, which faciliates developers writing code running on a 5mm*5mm sized MCU in Nodejs style
- Greatly speed up your IoT application developing process
- Lowest cost WiFi
- Less than $2 WiFi MCU ESP8266 integrated and esay to prototyping development kit
- We provide the best platform for IoT application development at the lowest cost
- Input Voltage:
- 3.3V via 3.3V pin
- 5.0V via Vin or USB
Specifications:
The Development Kit based on ESP8266, integates GPIO, PWM, IIC, 1-Wire and ADC all in one board.
- Power your development in the fastest way combinating with NodeMCU Firmware!
- USB-TTL included, plug&play
- 10 GPIO, every GPIO can be PWM, I2C, 1-wire
- PCB antenna
Documents:
- Schematic & PCB, Source Code, API Documents
- CH34X driver (Please ensure the board is plug in to computer USB port during driver installation)
- Windows (V3.5 Mar2019)
- Mac OS (V1.5 Mar2019)
- Linux (V1.5 Mar2019) (Normally is readily installed)
- CH34X Driver – Get the latest driver from factory
- Getting Started with NodeMCU V3 by sho8c1rkut
- Getting Started with NodeMCU V3, Arduino ecosystem and PlatformIO IDE by Danila Loginov
Packing List:
- 1 x NodeMCU V3 board
