Lem Tembak 20W mini hot melt glue gun with switch 7mm 11mm saklar

Name: Lem Tembak 20W mini hot melt glue gun with switch 7mm 11mm saklar
SKU: RG1-C05
Availability: OutOfStock

Rp30.000

Glue gun size: 132mm×110mm

Application: Suitable for glue sticks with a diameter of 6.8-7.3MM

Working voltage: AC: 100～230V

Working temperature: 180～200℃

Frequency: 50-60Hz

Power: 20W

Nozzle diameter: 1.8～2.0mm

Amount of molten glue extruded per minute: 3 to 5 grams

1. Performance characteristics

1. This product uses high-tech ceramic PTC thermistor as the heating element, which has fast heating speed, accurate constant temperature and saves energy consumption.

2. It can be used normally in AC or DC power supplies between 100V and 240V. It has a built-in safety fuse, making it safer to use.

3. The electrical insulation strength does not break down when energized at 3750V/minute, and the withstand voltage is 330V/3 minutes.

Instructions on glue gun leakage:

1. Because the glue is squeezed out by pulling the trigger to increase the internal pressure, so when the glue is just applied, there is still internal pressure that has not been released. Due to the effect of inertia, even if you do not use the glue gun at this time, The glue will still leak out a little until the internal pressure is released;

2. As for how much glue will leak after applying glue, it depends on the grade of the glue gun, the power and the melting point of the glue strip, as well as the strength and time when pulling the trigger. Therefore, the trigger should be released in advance based on the amount of glue that may continue to flow out due to inertia, and the appropriate trigger strength should be selected based on the required amount of glue to achieve the purpose of saving glue;

3. When no glue is applied for a long time, the glue will melt slightly later due to heat, the internal volume of the gun barrel will increase slightly, and the glue may flow out a little.

4. Ways to save glue:

A: When the amount of glue used at one time is not a lot, pull the trigger a little lighter. When the amount of glue used is large, pull the trigger a little harder.

B: Use a high-end glue gun, which is efficient, energy-saving, and can also save glue.

Sedang Kosong atau Habis